Filter
Top Products
GETTING STARTED [ 7]
B. Install the battery pack
Charge the battery pack for at least 15-20
hours before plugging the phone line into
your phone.
1)Press in on the battery cover release and slide the
cover down until it comes off.
2)Connect the battery pack connector observing
correct polarity (black and red wires) to the jack
inside the battery compartment.
Do not exert any force on this connection. It
could cause damage to the battery or to the
handset. The plastic connectors will fit together
in only one way. Once you are certain that you
have made a good connection, then insert the
battery pack into the battery compartment. Do
not pinch the wires.
3)Securely close the battery compartment cover by
sliding it up until it snaps into place.
4)Place the handset on the base. Remove the
beltclip, if attached, for face up charging.
GETTING STARTED
BATTERY PLUG-IN
DIRECTION
BLACK RED
Use only the Uniden
battery (BT-800) supplied
with your phone.
Replacement batteries are
also available through the
Uniden Parts Department.
(See page 5.)
TRU546 ENG 7/25/01 1:20 PM Page 7