Filter
Top Products
56
To operate from a remote location, use any touch-tone telephone, and follow these steps:
Call your telephone number and wait for the system to answer. If the answering system is off, it will answer
after about 10 rings and sounds a series of beeps.
During the greeting or the beeps (if answering system is off), press
[0] and enter your security code/PIN
within two seconds (see
Setting a Security Code or Personal Identication Number (PIN) on page 51).
The answering system announces the current time and the number of messages stored in memory. You hear
“To play incoming messages, press zero-two. For help, press one-zero” followed by a beep.
Enter a remote command from the chart below. You have 15 seconds to enter the rst command; after the
rst command, you have two seconds to enter each command.
Command Function Command Function
[0] and [1] Repeat a message* [0] and [6] Answering system on
[0] and [2] Play incoming messages [0] and [7] Memo record start/stop
[0] and [3] Skip a message [0] and [8] Greeting message record start/stop
[0] and [4] Delete a message [0] and [9] Answering system off
[0] and [5] Stop operation [1] and [0] Help
* If you press
[0] then [1] in the rst four seconds of a message, the system skips to the previous message.
If you press
[0] then [1] after the rst four seconds of a message, the system repeats the current
message.
When you nish, you will hear intermittent beeps indicating that the system is in the command waiting mode.
Enter another command from the chart within two seconds.
Hang up to exit the system. The answering system automatically returns to its normal standby setting.
1.
2.
3.
4.
5.
6.