Filter
Top Products
26
If you select ALL MEMORY, ARE YOU SURE? appears on the display screen. Move the cursor to select YES,
and then press
[select/ ].
If you select ONE MEMORY, nd the phonebook entry you want to transfer and then press [select/ ].
The phonebook entries will be transferred to the designated handset. During the copy process, the receiving
handset shows RECEIVING and the banner of the sending handset.
When the transfer is completed, DONE! appears on the handset.
Note: If your phonebook contains 100 entries, you cannot store any new phonebook entries. You will
hear a beep, and MEMORY FULL appears on the display. If the selected handset is out of range or
data transfer is canceled, UNAVAILABLE appears in the display. Phonebook listings will not be
transferred.
Programming Base Speed Dial Numbers (Dual Keypad Model Only)
The dual keypad base can store 10 speed dial numbers, [0] to [9]. Follow the steps below to store new speed
dial numbers in the base. (Handset speed dial numbers are stored as part of a phonebook entry. See
Creating
Phonebook Entries on page 22 for information on programming handset speed dial numbers.)
With the phone in standby, press
[memory].
Use the number keypad to enter the phone number; the phone number can contain up to 20 digits. If you
need the phone to pause between digits when it’s dialing (for example, to enter an extension or an access
code),press [redial/pause] to insert a two-second pause. You can also use more than one pause together if
two seconds is not long enough. Each pause counts as one digit.
Press
[memory] again, and then press the number key [0] to [9] where you want to store this phone number.
You will hear a conrmation tone.
5.
6.
7.
8.
1.
2.
3.