Filter
Top Products
42
Setting a WHAM Base ID
The WHAM base ID for the radio and the WHAM microphone you are installing must be set to
the same number.
1. Rotate PUSH/SELECT to select
BASE ID, then press PUSH/SELECT to select it.
The cursor moves to the first character of the base ID.
2. Rotate PUSH/SELECT clockwise to move forward through the displayed numbers or counter-
clockwise to move backward. When the number you want appears, press PUSH/SELECT to
select it. The cursor moves to the next number.
3. Repeat Step 2 for each of the base ID’s numbers. When you have entered all of the base
ID’s numbers, hold down PUSH/SELECT. A confirmation screen appears.
4. If the base ID you set appears correctly, rotate PUSH/SELECT to select
YES. The radio
saves the base ID you input. Otherwise, rotate PUSH/SELECT to select
NO.
5. Turn the radio off then turn it back on to enable the set base ID.
Changing the Radio Link Channel for a WHAM x 4
In case of noisy communication, you can chnage the link channel between the radio and the
WHAM x 4 microphone you use. This change process is automatic.
1. Rotate PUSH/SELECT to select WHAM x 4. Press PUSH/SELECT. Scroll to
CHANGE
LINK
, then press PUSH/SELECT to select it. YES and NO appear.
2. Rotate PUSH/SELECT to select either
YES or NO and push the knob to make your choice.
The WHAM x 4 menu displays to confirm your selection.
Renaming a WHAM x 4 Unit
1. From the WHAM x 4 Setup Menu, scroll to RENAME using PUSH/SELECT. Press the knob
once.
2. Scroll to the unit you want to rename. Press PUSH/SELECT to select it.
3. Rotate the PUSH/SELECT knob to change a letter of the current name using upper, lower
case and numerals in order. when you arrive at the chosen character, press PUSH/SELECT
to register your selection. Repeat that process until you have changed each character.
Press PUSH/SELECT to keep the current character.
4. After the final character change you can choose
YES to keep your changes or NO to discard
them.
Setting the Antenna
1. Scroll, using PUSH/SELECT to reach ANTENNA SEL. Push the knob once.
2. Rotate the PUSH/SELECT to select either
INTERNAL or EXTERNAL then press to make
your selection.
Using the Setup Screen