Filter
Top Products
40
3. Repeat Step 2 for each of the group MMSI's digits. When you have entered each of the
group MMSI's digits, a confirmation screen appears.
4. If the displayed group MMSI is correct, rotate PUSH/SELECT to select
YES, then press
PUSH/SELECT to confirm it. Otherwise, If the displayed group MMSI is not correct, rotate
PUSH/SELECT to select NO, then press PUSH/SELECT to confirm it. Then repeat Steps 2
and 3 to enter the correct group MMSI.
Setting Channel Scan
You can set the radio so it scans channel you stored in the radio’s memory or all of the radio’s
channels.
1. Rotate PUSH/SELECT to select
CHANNEL SCAN, then press PUSH/SELECT to select it.
2. To set the radio to scan channels you saved in the memory, rotate PUSH/SELECT to select
MEMORY CHAN, then press PUSH/SELECT to confirm it. Otherwise, rotate PUSH/
SELECT to select
ALL CHAN, then press PUSH/SELECT to confirm it.
Setting RX Sensitivity
1. Rotate PUSH/SELECT to select RX SENS, then press PUSH/SELECT to select it.
2. To set the radio to receive distant stations, rotate PUSH/SELECT to select
DISTANT, then
press PUSH/SELECT to confirm it. Otherwise, to set the radio to receive nearby stations,
rotate PUSH/SELECT to select
LOCAL, then press PUSH/SELECT to confirm it.
Displaying Time and Position
You can adjust the way the radio displays information. You can set it so it displays information
by channel name, local time, or position.
1. Rotate PUSH/SELECT to select
DISP TIME/POS, then press PUSH/SELECT to select it.
2. To set the radio to display channel name, rotate PUSH/SELECT to select
CHANNEL NAME,
then press PUSH/SELECT to confirm it. Otherwise, to set the radio to display local time,
rotate PUSH/SELECT to select
LOCAL TIME, then press PUSH/SELECT to confirm it.
Otherwise, to set the radio to display position, rotate PUSH/SELECT to select
POSITION,
then press PUSH/SELECT to confirm it.
Setting the XTRACK Beep Options
You can set the XTRACK feature to sound a tone when you are off course based on your input
GPS data. From the SETUP screen, rotate PUSH/SELECT until
XTRACK is highlighted and
press the knob. Highlight either
ON or OFF and push to select it.
Using the Setup Screen