Filter
Top Products
39
4. Repeat Step 3 for each of the FIPS code’s numbers. When you have entered all of the
FIPS code numbers, hold down PUSH/SELECT. A confirmation screen appears.
5. If the FIPS code you set appears correctly, rotate PUSH/SELECT to select
YES. The radio
saves the FIPS code you input. Otherwise, rotate PUSH/SELECT to select
NO.
Deleting a FIPS Code
1. Rotate PUSH/SELECT to select DELETE, then press PUSH/SELECT to select it.
A screen appears where you can delete the FIPS code.
2. If you want to delete the displayed FIPS code, rotate PUSH/SELECT to select
YES, then
press PUSH/SELECT to confirm it. The FIPS code is deleted.
Otherwise, If the displayed FIPS code is not the one you want to delete, rotate PUSH/
SELECT to select
NO, then press PUSH/SELECT to confirm it. The FIPS code is not
deleted.
Disabling Auto Channel Switch
This option lets you set the radio so it does not automatically change the channel when it
receives a DSC call. If the radio receives an individual call when Auto Channel Switch is
turned off, the radio replies
UNATTENDED to the calling radio and does not tune to the
channel requested by the calling radio.
1. Rotate PUSH/SELECT to select
AUTO CH SW, then press PUSH/SELECT to select it.
AUTO CH SW and ON and OFF appear.
2. To turn off auto channel switch, rotate PUSH/SELECT to select
OFF, then press PUSH/
SELECT to confirm it. Auto channel switch is turned off. To turn on auto
channel switch, rotate PUSH/SELECT to select
ON, then press PUSH/SELECT to
confirm it. Auto channel switch is turned on.
Position Reply
This option lets you set the radio so you can transmit an acknowledgement automatically or
manually when it receives a Position Request Call.
1. Rotate PUSH/SELECT to select
POS REPLY, then press PUSH/SELECT to select it.
AUTO and MANUAL appear.
2. To set the radio to transmit an acknowledgement automatically, rotate PUSH/SELECT to
select
AUTO, then press PUSH/SELECT to confirm it. Otherwise, rotate PUSH/SELECT
to select
MANUAL, then press PUSH/SELECT to confirm it.
Setting Up a Group MMSI
You can program a group MMSI. A group MMSI is 9 digits in length.
1. Rotate PUSH/SELECT to select
GROUP MMSI, then press PUSH/SELECT to select it.
2. To enter the first digit of the group MMSI, rotate PUSH/SELECT until the digit appears,
then press PUSH/SELECT. The digit you entered appears and the cursor moves to the
next position.
Using the Setup Screen