Filter
Top Products
36
Setting the Local Time - Time Adjust and Time Entry
If you connect an optional GPS module to the radio, the radio automatically sets the local time.
Follow these steps to manually enter the local time.
1. Rotate PUSH/SELECT to select
TIME ADJUST, then press PUSH/SELECT to select it. A
menu screen appears to let you select
AUTO or MANUAL. In AUTO the radio checks the
current time zone and adjusts the local time automatically. If you select
MANUAL,
you can fine tune the local time from the GPS plus or minus one hour.
2. Rotate PUSH/SELECT clockwise to set the time forward or counterclockwise to set it back-
ward. When the desired time appears, press PUSH/SELECT to select it.
3. If no GPS is attached, rotate PUSH/SELECT to
TIME ENTRY. Press to select it. If the local
UTC time appears correctly, rotate PUSH/SELECT to select
YES. The radio sets the local
UTC time to the time you set. Otherwise, rotate PUSH/SELECT to select
NO and re-enter the
correct UTC time.
Setting the Position
To manually set (no GPS connected) the radio’s position, rotate PUSH/SELECT to POS
ENTRY
and select it. Enter your latitude and longitude.
Notes:
• To save the UTC time as well as the latitude, and longitude you entered, at the completion
of your entry, select
YES to keep your entry or NO to discard them.
• When you set the time in this mode, be sure to set it to the current UTC time, not local time.
• If the radio does not receive valid GPS data for at least 4 hours, it sounds a tone and
PLEASE INPUT UTC TIME AND POSITION appears. Refer to the start of this section for
setting the position manually and the section above that for manual time setting.
Setting Daylight Saving Time
1. Rotate PUSH/SELECT to select DAYLIGHT SAVE, then press PUSH/SELECT to select it.
DAYLIGHT SAVE and a confirmation screen appear.
2. To set the radio to daylight saving time, rotate PUSH/SELECT to select
ON. The radio adjusts
the displayed time for Daylight Saving Time. Otherwise, rotate PUSH/SELECT to select
OFF.
Setting Units
This option lets you adjust the displayed bearing and distance/speed units .
1. Rotate PUSH/SELECT to select
UNITS, then press PUSH/SELECT to select it.
A screen showing the unit options appears.
2. To set the unit for bearing, select
BEARING. Otherwise, to set the unit for distance/speed,
select
DIST/SPEED.
3. Rotate PUSH/SELECT clockwise to set the desired unit, then press PUSH/SELECT to select
it.
Using the Setup Screen