Uniden UH-099 Two-Way Radio User Manual


 
Receiver SELCALL ID
To program your own receiver SELCALL ID, perform the following procedure.
Press and Hold
ITSQ I,then turn on the Power.
1.1 Initial Display and Status (factory default:
00000)
RX SELCALL Code Programming
,-, It ,-, ,-, ,-,
UUUUf-t
TSQ I
,~ "
~ ~
1.2 When the IMEM Ikey is pressed while in this condition, the last digit will begin
ENT
to flash and RX Tone Editing is possible.
,-, ,-, ,-, ,-, ,-,
f-tf-tf-tf-tU
LFlaShing
Use the <J or [> to select the digit position. The selected digit will flash.
Rotatethe 0 to change the active digit value.
Channel Knob
TSQ I
,~ "
~ ~
When finished, press IMEM Ito store the RX Code into memory.
ENT
The programmed code flashes and three successive beeps are heard.
Press ITSQ Ifor about 1.5 seconds to exit. The radio returns to normal operation.
Or press ITSQ Imomentarily to go to the next programmable parameter.
1.3 Selecting 5 or 6 Tone Format
1.31 From 5 to 6 Tone Format Setting
While the 5th digit is flashing, press [>. A space bar [ -] will appear and
flash.
Page 20