Filter
Top Products
Removing Open Scan Channels
When the radio is initially turned on, all 40 channels are programmed in the OPEN
SCAN MEMORY.
If you do not wish to scan some particular channels (e.g. if one or more channels are
continually busy and always causing the scanning function to pause), you can remove
these channels from the scan group by using the following procedure:
1.
Cancel scal)ning (if active).
2.
Select the OPEN SCAN mode by pressing the OS/GS button when in the GS
mode. The OS indicator should appear. The GS indicator should not appear.
3.
Rotate the CHANNEL SELECTOR knob until the channel you wish to remove
is displayed on the CHANNEL INDICATOR.
Note that the MEM indicator is lit, indicating that this channel is currently included in
the scan group.
4.
Press and hold the MEM button for about 1.5 seconds until a beep is heard
twice.
The selected channel has now been removed from the scan group and will not be
included when scanning has commenced and the MEM indicator will not be displayed
on that channel.
Continue steps 3 and 4 to remove any other channels you do not wish to scan.
Page 11
. now off.
'MEM'Icon
MEM indicator IS
Remove
OFF
NOTE: The Select
CHANNELSelect CHANNEL
MEM
1=1 OS LID
lLJ
1)) I
.... BEEPI'"