Filter
Top Products
GETTING STARTED[ 6 ]
Charge the battery pack for at least 15-20 hours before plugging the
phone line into your phone.
1)Press in on the battery cover release and slide the cover down until it
comes off.
2)Connect the battery pack connector observing correct polarity (black and red
wires) to the jack inside the battery compartment.
Do not exert any force on this connection. It could cause damage to the
battery or to the handset. The plastic connectors will fit together in only one
way. Once you are are certain that you have made a good connection, then
insert the battery pack into the battery compartment. Do not pinch the wires.
3)Securely close the battery compartment cover by sliding it up until it snaps
into place.
4)Place the handset on the base. Remove the beltclip, if attached, for face
up charging.
Battery use time (per charge)
From fully charged
• Seven hours continuous use
• Fourteen days when the handset is in the standby mode
B. Install the battery pack
Use only the
Uniden battery
(BT-905) supplied
with your phone.
Replacement
batteries are also
available through
the Uniden Parts
Department.
(See page 4.)
2960_eng combined.qxd 1/22/01 11:50 AM Page 6