Filter
Top Products
Standard wall plate mounting
This phone can be mounted on any standard wall plate.
1)Plug the AC adapter into the
DC IN 9V jack.
2)Wrap the AC adapter cord inside the molded wiring channel as shown.
3)Plug the AC adapter into a standard 120V AC wall outlet.
4)Place the handset on the base unit and charge for 15-20 hours.
5)Plug the telephone line cord into the
TEL LINE jack. Wrap the cord inside
the molded wiring channel as shown.
Mounting the Base Unit on a Wall
DO NOT use an
outlet controlled
by a wall switch.
Setting the handset retainer clip for wall mounting
1)On the base unit, pull the handset retainer clip out of the slot and rotate it
clockwise 180 degrees.
2)Flip the retainer clip from front to back. Slide it back into the slot so that the lip
of the retainer is up and the
▼ is down. The retainer holds the handset in place.
[ 10 ]
GETTING STARTED
If you have wall
mounted the
base, you have to
remove the belt-
clip to hang the
handset with the
display facing
forward.
6)Plug the telephone line cord into the telephone outlet.
7)Raise the antenna to a vertical position.
8)Align the mounting slots on the base with the mounting posts on the wall.
Then push in and down until the phone is firmly seated.
2960_eng combined.qxd 1/22/01 11:50 AM Page 10