Filter
Top Products
[ 17 ]
MEMORY DIALING
BASICS
• In memory
dialing
operation, you
must press a
key within 20
seconds or the
phone will
return
to standby.
If you return
the handset to
the base, the
phone will
return to
standby also.
• You have 20
seconds after
pressing
m to
enter the
number you
wish to store.
Otherwise, an
error tone will
sound.
Storing Phone Numbers and Names
Memory Dialing allows you to dial a number using just a few key strokes. Your EXI2960/EXI2965 stores up
to 10 names/numbers in handset.
1)Press and hold
m until ¨Memory Store¨ is displayed.
2)Press
▲ and ▼ or enter a number (0 - 9) to select the memory location where you
would like to store the number.
3)Press
select. The following screen appears and a cursor flashes indicating that the
display is ready for the name to be entered.
If this screen appears, the selected memory location is already stored. Then you must
either change the entry in this location, clear the entry in this location, or select
¨
Go Back¨ to choose another location.
4)To enter a name (up to 14 characters), use the number keys.
• See the “Steps for entering names and special characters”. (See page 18)
• Use
# and
*
/tone to move the cursor to the desired location.
• Use
delete to delete characters as needed.
• Press and hold
delete to delete all the characters.
• If a name is not required, go to step 5.
5)Press
select. ¨Store Number¨ is displayed. The cursor flashes indicating that the display is ready for the
number to be entered.
6)Use the number keys to enter the phone number. The phone number cannot exceed 20 digits.
Use
redial/p to enter pause in the dialing sequence.
The display shows a ¨
P¨. Each pause counts as one digit and represents a two second
delay of time between the digits as they are sent.
Use
delete to delete digits as needed.
Memory Store
1
2
Store Name
Edit Memory 1
Delete Memory 1
Go Back
Store Number
8002971023
Store Number
7)Press select. The handset beeps and displays the confirmation screen. Memory
storage is complete. For example, if you store a name and number into memory
location number 7, the display shows ¨
Memory 7 Stored¨. If you store the number
into
memory location number 8, the display shows ¨
Memory 8
¨.
After about 2
seconds, ¨
Memory Store¨ is displayed. Repeat steps 2 - 7 to store more numbers.
8)Press
m to return to standby mode.
Memory 7 Stored
Memory Store
7 UNIDEN CORP
8 <Memory 8>
MEMORY DIALING
BASICS
2960_eng combined.qxd 1/22/01 11:50 AM Page 17