Filter
Top Products
37
PROGRAMMING YOUR DX8200
PROGRAMMING
2. The
talk/batt low
LED flashes.
3. Enter the number on the Handset keypad.
4. Press .
5. Enter a number ( ~ ) from the Handset keypad for the memory location.
6. You will hear a confirmation beep and the
talk/batt low
LED goes out.
Write the stored number and its memory
location number on one of the enclosed stickers.
NOTE: You man enter a delay between numbers (for accessing a switchboard, or long
distance service) by pressing the button on the Handset at the point
in the number sequence you wish to pause. The button counts as
one digit. Pressing more than once will increase the length of the
pause between numbers.
NOTE: After pressing the second time, you have 20 seconds to enter the number
you wish to store. Otherwise, an error tone will sound and the unit returns to Standby.
8200-OM.qxd 22/10/98 15:44 Page 37