Filter
Top Products
33
SETTING UP YOUR PHONE
SETTING UP YOUR PHONE
2. After the Handset stops beeping, remove it from the base Unit.
3. Wait for 5 seconds, place the Handset
back on the Base Unit.
4. The
status
LED on the Base Unit will
flash rapidly to indicate that the Digital
Security Code is set to one of the more
than 65,000 codes.
To re-establish communication between the
Handset and Base Unit:
1. Restore power to the Base Unit.
2. Place the Handset back on the Base Unit.
3. The
status
LED on the Base Unit will flash rapidly to indicate that the Digital
Security Code is set.
NOTE: If the Base Unit loses power while the Handset is off the Base, the Digital Code may
be erased. When this happens, the Handset will not function.
8200-OM.qxd 22/10/98 15:44 Page 33