Uniden 6035 + 1 Cordless Telephone User Manual


 
52
Symptom Suggestion
Cannot access answering
system from a remote
phone.
Make sure you are using the correct PIN number.
Make sure that the touch-tone phone you’re using can transmit the tone for at
least two seconds. If it cannot, try using a different touch-tone phone.
Liquid Damage
Moisture and liquid can damage your cordless phone.
If the handset or base is exposed to moisture or liquid, but only the exterior plastic housing is affected, wipe off
the liquid, and use as normal.
If moisture or liquid has entered the plastic housing (i.e. liquid can be heard in the phone or liquid has entered the
handset battery compartment or vent openings on the base), follow the steps below:
Handset Base
Remove the battery cover and leave it off for 1)
ventilation.
Disconnect the battery pack. Leave the battery 2)
cover off and the battery pack disconnected for at
least 3 days.
Once the handset is completely dry, reconnect the 3)
battery pack and the battery cover.
Recharge the handset’s battery pack for 15 to 20 4)
hours before using.
Disconnect the AC adapter from the base, cutting 1)
off electrical power.
Disconnect the telephone cord from the base.2)
Let dry for at least 3 days. 3)
IMPORTANT: You must unplug the telephone line while recharging the battery packs to avoid charge interruption.
CAUTION: DO NOT use a microwave oven to speed up the drying process. This will cause permanent
damage to the handset, base and the microwave oven. After following these steps, if your
cordless telephone does not work, please visit Uniden’s customer support page at www.uniden.
com.au (Australian model) or www.uniden.co.nz (New Zealand model).
DECT6035, 6035+1 OM.indb 52DECT6035, 6035+1 OM.indb 52 8/8/07 3:25:47 PM8/8/07 3:25:47 PM