Filter
Top Products
41
While your answering system is set to “Announce only,” the message counter LED on the base displays “A.” If you
are using the prerecorded greeting, the system automatically switches to the following message: “Hello, no one is
available to take your call. Please call again.” If you are using a personal greeting, the system continues to use that
greeting.
Activating the Message Alert
The message alert feature sounds a short alert tone every fi fteen seconds whenever you have a new message.
To turn on the message alert:
On the handset, press 1) [Menu/Select]. Select the ANSW. SETUP menu, and then the MESSAGE ALERT
submenu.
Move the cursor to select ON or OFF.2)
Press 3) [Menu/Select]. You will hear a confi rmation tone.
Activating Call Screening
Your phone allows you to listen to callers leaving you a message. This call screen feature can be turned on or off.
On the handset, press 1) [Menu/Select]. Select the ANSW. SETUP menu and then the CALL SCREEN submenu.
Move the cursor to select ON or OFF.2)
Press 3) [Menu/Select]. You will hear a confi rmation tone.
Setting a Security Code or Personal Identifi cation Number (PIN)
To play your messages from a remote location, you will need to enter a two-digit security code or Personal
Identifi cation Number (PIN). The default security code is 80.
On the handset, press 1) [Menu/Select]. Select the ANSW. SETUP menu, and then the SECURITY CODE
submenu.
Use the number keypad (2) [0] through [9]) to enter a two-digit security code (00-99).
Press3) [Menu/Select]. You will hear a confi rmation tone.
DECT6035, 6035+1 OM.indb 41DECT6035, 6035+1 OM.indb 41 8/8/07 3:25:45 PM8/8/07 3:25:45 PM