Filter
Top Products
25
this problem. The technician who installed your DSL service might
have left some filters for you; if not, call your DSL provider or look in
any electronics store.
Plug the DSL filter into the telephone wall jack and plug your phone’s
base into the filter. Make a test call to make sure the noise is gone.
Changing from Tone to Pulse Dialing
Your phone can communicate with the telephone network in two
different ways: tone dialing or pulse dialing. These days, most
telephone companies use tone dialing. If your phone company uses
pulse dialing, you will need to change your phone’s dial mode.
From a handset, open the menu & select
Global Setup
.
Select
Dial Mode
, then select
Pulse
. The phone sounds a
confirmation tone.
If you use pulse dialing and you need to send DTMF tones during a
call (if you're using an automated response system, for example),
press to temporarily switch to tone dialing. When the call ends, the
phone automatically returns to pulse dialing mode.
Resetting and Registering Handsets
If you are having trouble with a handset or if you want to replace one,
you need to clear the registration information from the base and the
handset:
Do you have the base the handset is registered to?
Yes No
Press & hold
END
and
#
until the
System
Reset
menu appears (about 5 seconds).
Select
Deregister HS.
The display lists
all registered handsets.
Select the handset you want to reset.
When the phone asks you to confirm,
select
Yes
. The handset clears its
information from the base & deletes it
own link to the base.
1.
2.
3.
4.
Press & hold
END
and
#
until
the
System Reset
menu
appears (about 5 seconds).
Select
Base Unavailable
.
When the phone asks you
to confirm, select
Yes
. The
handset deletes its own link
without contacting the base.
1.
2.
3.
When you reset a handset (or if you buy a new one), that handset
displays a
Handset Not Registered
message. If you see this message
on a handset, you need to register it to a base before you can use it.
1)
2)