Filter
Top Products
58
Precautions!
--Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
--Consult the dealer or an experienced radio/TV technician for help.
Radio interference
Radio interference may occasionally cause buzzing and humming
in your cordless handset, or clicking noises in the base. This
interference is caused by external sources such as TV, refrigerator,
vacuum cleaner, uorescent lighting, or electrical storm. Your unit is
NOT DEFECTIVE. If these noises continue and are too distracting,
please check around your home to see what appliances may be
causing the problem. In addition, we recommend that the base
not be plugged into a circuit that also powers a major appliance
because of the potential for interference. In the unlikely event that
you consistently hear other voices or distracting transmissions
on your phone, you may be receiving radio signals from another
cordless telephone or other source of interference.
Finally, it should be noted that some cordless telephones operate
at frequencies that may cause interference to nearby TVs and
VCRs. To minimize or prevent such interference, the base of the
cordless telephone should not be placed near or on top of a TV or
VCR. If interference is experienced, moving the cordless telephone
farther away from the TV or VCR will often reduce or eliminate the
interference.
Cordless telephone privacy
Cordless telephones are radio devices. Communications between
the handset and base of your cordless telephone are accomplished
by means of radio waves which are broadcast over the open
airways. Because of the inherent physical properties of radio
waves, your communications can be received by radio receiving
devices other than your own
cordless telephone unit. Consequently, any communications using
your cordless telephone may not be private.
I.C. Notice
Terminal equipment
NOTICE: This equipment meets the applicable Industry
Canada Terminal Equipment Technical Specications. This is
conrmed by the registration number. The abbreviation, IC,
before the registration number signies that registration was
performed based on a Declaration of Conformity indicating that
Industry Canada technical specications were met. It does not
imply that Industry Canada approved the equipment.
NOTICE: The Ringer Equivalence Number (REN) for this
terminal equipment is marked on the equipment itself. The REN
assigned to each terminal equipment provides an indication
of the maximum number of terminals allowed to be connected
to a telephone interface. The termination on an interface may
consist of any combination of devices subject only to the
requirement that the sum of the Ringer Equivalence Numbers
of all the devices does not exceed ve.
Radio equipment
The term “IC:” before the radio certication number only signies
that Industry Canada technical specications were met.
Operation is subject to the following two conditions: (1) this
device may not cause interference, and (2) this device must
accept any interference, including interference that may cause
undesired operation of the device. “Privacy of communications
may not be ensured when using this telephone.”