Uniden D17882T Cordless Telephone User Manual


  Open as PDF
of 28
 
English - 23
Answering system problems Possible solutions
My outgoing message is gone.
x If there was a power failure, re-record your
personal outgoing message.
I can’t hear the base speaker.
x Make sure call screening is turned on.
x Change the base speaker volume.
Messages are incomplete.
x Increase the
Record Time
.
x Delete messages (memory may be full).
The system keeps recording when
I answer on an extension.
x You may have to change the line mode.
Contact Customer Service for instructions.
Installing a Line Filter or DSL Filter
AtelephonelinefilterorDSLfilterpreventsservicesthatusethephone
linefromcausinginterferenceonyourphone.Togetalinefilter,contact
yourserviceproviderorlookinanelectronicsstore.
Plugthefilterintothetelephonewalljackandplugthebaseintothefilter.
Makeatestcalltomakesurethenoiseisgone.
Liquid Damage
CAUTION: If the base is covered in liquid, disconnect the adapter
and phone cord from the wall before touching it.
Iftheliquidisonlyontheexteriorhousingofthebaseorhandset,wipeit
offanduseasnormal.Ifyoucanhearliquidinsidethehousing:
1. Removeallcompartmentcovers,anddisconnectallcablesandcords.
2. Ifliquidisleakingfromanyventorhole,turnthephonesothatthe
leakingventfacesdown.Ifnot,placethelargestventfacedown.
3. Letdryforatleast3days.Checkforliquidinsidethephonebefore
replacingcompartmentcovers&reconnectingcords.
Resetting Stations
Unplugthebasetoresetit.Plugitbackinafteratleastaminute.
Ifyouhavetroublewithahandsetorifyouwanttoreplaceone,clearthe
registrationinformationfromthebaseandthehandset:
1. Press&hold
enD
and
#
atthesametimeuntilyouseethe
System Reset
menu.
2. Ifyoustillhavethebasethehandsetisregisteredto,select
Deregister
HS
,thenselectthehandsetyouwanttoreset.Ifyoudon’thavethatbase
anymore,select
Base Unavailable
.
3. Toconfirm,select
Yes
.Thehandsetdisplays
Handset not registered
.
 previous next