Filter
Top Products
48
Press the OK soft key. MONITOR appears on the handset or the base, and
MONITORING appears on the base or the handset, and you hear sounds in the
room where the handset or base is installed.
To turn off the Room Monitor, press the
END soft key or [ ] on either handset or
return the handset to the cradle.
If you want to prevent other handsets or the base from monitoring the station, press the
MENU soft key on the handset or base. Select the HANDSET SETUP menu or the BASE
SETUP menu, and then the ROOM MONITOR submenu. Select OFF and press the
OK
soft key.
Note:
This feature only works when both handsets are within range of the base.
If the party is out of range, UNAVAILABLE appears in the display and the operation will be canceled.
While a pair of handsets is in Room/Baby Monitoring mode, only the Handsets in monitoring mode can re
-
ceive incoming calls. To resume normal telephone operation, you should terminate the monitoring session by
pressing the
END soft key on either handset.
Tone Dialing Switch Over
If your telephone company requires pulse dialing, you can switch to tone dialing after the call connects. This feature
is useful when you need tone dialing to use automated menu systems, such as telephone bank tellers, telephone
prescription rells, customer support menus, etc. If your phone is set to pulse dialing, make your call normally. Once
your call connects, press
[
tone
] on the handset or base. Any digits you enter from then on will be sent as tone dialing.
When this call ends, the phone automatically returns to pulse dialing.
3)
4)
•
•
•
To which unit?
Handset #2
Handset #3
BACK DELETE OK
To which unit?
Handset #2
Handset #3
BACK DELETE OK
Monitoring
｣｣
Handset #2
END
Monitoring
｣｣
Handset #2
END