Filter
Top Products
47
Answering an Intercom Page
When the intercom page tone sounds, the display will show the ID of the station that is
paging.
Press
[ /ash], [int’com/hold], or the ANSWER soft key (or [int'com/hold], [ ]
or the
ANSWER soft key on the base). Or press a number key, [
tone
], or [#] (when
Any Key Answer is enabled), or pick up the handset from the cradle (when AutoTalk is on).
To hang up an intercom page, press the
END soft key or [ ] on either handset (or [int'com/hold], on the
base).
Note:
If the party is busy, the handset returns to standby. If the party is out of range, UNAVAILABLE appears in the
display and the operation will be canceled.
If you receive an outside or intercom call or page while selecting the other handset, the operation is canceled.
If you do not select a handset within 30 seconds, the operation will be canceled.
If the party does not answer within one minute, the operation is canceled.
Room/Baby Monitor
This feature allows you to monitor sounds in another room. Place a
handset (or the base) in the room you wish to monitor; it will function as
a microphone. Another handset (or the base) can be set to function as a
remote speaker, allowing you to monitor sounds in the room.
Press the
MENU soft key and enter the Room Monitor menu. TO
WHICH UNIT? appears.
Select the handset or base you want to monitor by using
[ ] or
[ ].
1)
2)
•
•
•
•
1)
2)
Intercom
｢｢
Handset #1
ANSWER
Intercom
｢｢
Handset #1
ANSWER