Filter
Top Products
GETTING STARTED
GETTING STARTED [ 9]www.uniden.com
The last number dialed in the redial memory, the Menu display options, the names and
the numbers stored in the memory locations or CID list are retained for up to 30 minutes
while you replace the battery pack.
Low battery alert
When the battery pack is very low and needs to be charged,
the phone is programmed to eliminate functions in order to
save power. If the phone is not in use,
Low Battery flashes
on the LCD and none of the keys will operate.
If the phone is in use,
Low Battery flashes and the handset
beeps. Complete your call as quickly as possible and return the
handset to either cradle for charging.
• Even when the
battery pack is not
being used, it will
gradually discharge
over a long period of
time. For optimum
performance, be sure
to return the handset
to either cradle after
a telephone call.
Cleaning the battery charging contacts
To maintain a good charge, it is important to clean the
charging contacts on the handsets, main base unit and
charging cradle once a month. Using water only, dampen
a cloth to clean the charging contacts. Then make sure
to go back over the charging contacts with a dry cloth
before returning the handsets to the main base unit or
charging cradle to charge.
Do not use paint thinner, benzene, alcohol, or other chemical products.
Doing so may discolor the surface of the telephone and damage the finish.
• Talk Mode -
The handset is off either
cradle and the talk/flash
key has been pressed,
enabling a dial tone.
• Standby Mode -
The handset may be sitting
in or off either charging
cradle but is NOT in use.
The talk/flash key has not
been pressed and there is
no dial tone.