Filter
Top Products
GETTING STARTED
GETTING STARTED [ 17]www.uniden.com
1) When the phone is in the standby mode, press and hold the
cid/menu key. The following screen appears.
2) Press the
vol/ring/ key three times to select ¨Dial¨.
3) Press the
select key to toggle between ¨Tone¨ and ¨Pulse¨.
4) Press the
end key or return the handset to the base unit to complete the setting.
The handset returns to standby mode.
Setting the language
1) When the phone is in the standby mode, press and hold the
cid/menu key. The following screen appears.
2) Press the
vol/ring/ key four times to select ¨Language¨.
3) Press the
select key to toggle between ¨Eng¨, ¨Fr.¨ and
¨
Esp¨.
4) Press the
end key or return the handset to the base unit to complete the setting.
The handset returns to standby mode.
• Make sure your battery
pack is fully charged
before choosing the
dialing mode.
• If you are not sure of
your dialing system,
set for tone dialing.
Make a trial call. If the
call connects, leave the
setting as is. Otherwise
set for pulse dialing.
• If your phone system
requires pulse dialing
and you need to send
the DTMF tones for
certain situations
during a call, you may
"switch-over" to tone
dialing. (Refer to "Tone
Dialing Switch-over" on
page 20.)
Choosing the dialing mode
Most phone systems use tone dialing which sends DTMF tones through the phone
lines. However, some phone systems (such as those in rural areas) still use pulse
dialing. The default setting is tone dialing. Depending on your dialing system, set
the mode as follows: