Uniden EXI3246 Series Cordless Telephone User Manual


 
C. Connect the base unit
1) Connect the AC adapter to the DC IN 9V jack
and to a standard 120V AC wall outlet.
2) Set the base on a desk or tabletop, and
place the handset in the base unit.
3) Raise the antenna to a vertical position.
4) Make sure that the
charge/in use LED illuminates.
If the LED does not illuminate, check to see that the AC adapter is plugged in
and the handset makes good contact with the base charging contacts.
GETTING STARTED[ 12 ] www.uniden.com
Place the power cord
so that it does not
create a trip hazard or
where it could
become chafed and
create a fire or
electrical hazard.
Use only the
supplied AD-0001
AC adapter.
Do not use any other
AC adapter.
Connect the AC adapter to a continuous power supply.
Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.
Route the cord.
After installing the battery pack in the handset, charge your handset at least 15-20
hours before plugging into the phone line
.
5) Once the handset battery pack is fully charged, connect the
telephone line cord to the
TEL LINE jack and to a telephone
outlet.
Modular
If your telephone outlet isn't modular,
contact your telephone company
for assistance.