Filter
Top Products
GETTING STARTED
GETTING STARTED [ 11]www.uniden.com
• Even when the
battery pack is not
being used, it will
gradually discharge
over a long period
of time. For optimum
performance, be sure
to return the handset
to the base unit after
a telephone call.
• Talk Mode -
The handset is off the
base and the
talk/flash key has
been pressed,
enabling a dial tone.
• Standby Mode -
The handset is not in
use, off the base, and
the talk/flash key
has not been pressed.
A dial tone is not
present.
Cleaning the battery charging contacts
To maintain a good charge, it is important to clean the
charging contacts on both the handset and the base unit
once a month. Using water only, dampen a cloth to clean
the charging contacts. Then make sure to go back over the
charging contacts with a dry cloth before returning the
handset to the base to charge.
Caution: Do not use paint thinner, benzene, alcohol, or
other chemical products. Doing so may discolor the
surface of the telephone and damage the finish.
The last number dialed in the redial memory, and the
numbers stored in the memory locations are retained for
up to 30 minutes while you replace the battery pack.
Low battery alert
When the battery pack is very low and needs to be charged,
the phone is programmed to eliminate functions in order to
save power. If the phone is not in use, ¨
Low Battery¨
appears on the LCD and none of the keys will operate.
If the phone is in use, ¨
Low Battery¨ flashes and the
handset beeps. Complete your conversation as quickly as
possible and return the handset to the base unit for charging.