Filter
Top Products
76
Scroll to Tone-Out Setup and press E/yes.
Scroll to Tone-Out (0-31) and press E/yes.
Note: Close Call DND/Pri and Weather Alert Priority do not operate in this mode.
Edit Name Start Delay Time
Set Frequency Set Alert
Set Tone Set Audio AGC
Edit Name
See Data Naming.
Set Frequency
Edit Frequency Enter the frequency and press E/yes.
Set Modulation
Auto, NFM, FM
Set Attenuator
On or Off
Set Tone
Edit Tone A and press E/yes. Enter the tone and press E/yes to save.
Edit Tone B and press E/yes. Enter the tone and press E/yes to save.
Press Menu to return.
For two-tone pages, enter the tones (in Hz) for tone A and tone B.
For one-tone pages using short tones between 1.25 and 3.75 seconds, enter tone for
tone A, and 0 for tone B.
For long-tone pages, such as group pages of more than 3.75 seconds, enter 0 for tone
A, and the tone for B.
To search for tones, leave the tones for A and B at 0.
Set Delay Time
0 - the scanner resumes standby as soon as the carrier drops after a page.
1, 2, 3, 4, 5, 10, 30 - (seconds): the scanner resumes standby mode after the carrier drops
and the selected time expires.
Infinite - you must press Hold after a page to resume standby mode.
Set Alert
Set Alert Tone
Alert 1-9 or Off.
Set Level
Level 1-15 or Auto (the master volume level).
Set Alert Light
Set Color
Off, Blue, Red, Magenta, Green, Cyan, Yellow, or White.
Set Pattern
On, Slow Blink, or Fast Blink.