Filter
Top Products
12
Strata CTX Standard Telephone User Guide October 2002
Call Forward
Advanced Operation
Call Forward Procedures
The following table contains Call Forward Button sequences. You can do a Call Forward function by
one, entering the button sequence as described, or two, programming a flexible button to perform the
sequence. See “Call Forward Procedure” on page 12 for instructions on programming a flexible
button.
Some Call Forward features require a Pass Code entry. Use the following procedure to change your
Pass Code.
➤
To change your Pass Code
➤ Lift the handset, press
+ ext. no. + old Pass Code (1~15 digits) + + new Pass Code (1~15
digits) + .
➤
To use the Call Forward button sequence
➤ Follow the instructions in the following table, shown under “Button Sequence.” Some features
require additional input, such as:
♦
Destination – If the destination is an outside number, press
after entering the destination.
The CTX accepts destination numbers of up to 32 digits.
♦
Timer – This is a two digit entry representing how long (8 to 60 seconds) your telephone
should ring before forwarding the call. If you enter one digit, you must press
after entering
the single digit.
♦
Pass Code – A four-digit code established by system programming to prevent unauthorised
changes. The code applies to the station to be forwarded; not to the station entering the code.
Note
In the following table, (Tone) means that a confirmation tone will play at that point in the
sequence.
Table 1 Call Forward Procedure
Feature Button Sequence
Call Forward Any Call (Internal and Incoming Line)
All Calls Lift handset, press
(Tone) + Destination No. + (Tone)
Busy Lift handset, press
(Tone) + Dest. No. + (Tone)
No Answer Lift handset, press
(Tone) + Dest. No. + (Tone) + Timer +
Busy No Answer Lift handset, press + Dest. No. + + Timer +
Cancel Lift handset, press (Tone)