Filter
Top Products
10 11
Getting started
Set the day and time
If you have more than one handset registered to your base, you only need to set the date and time on
one handset and the other handsets will be automatically updated once you make a call, or press the
?PW^_]L
or
.LWW^
keys.
1. Press
8PY`
to open the main menu.
2. Press
.LWW^
or until the display shows Date/Time and press
8PY`
.
3. Set date/time is displayed, press
8PY`
.
4. The current year setting is displayed; enter the last 2 digits of the year (e.g. press 0 then 6 for 2006)
and press
8PY`
.
5. Enter 2 digits for the date and 2 for the month (e.g. for 5th August, press 0 5 0 8 press
8PY`
.
6. Enter 2 digits for the hour and 2 for the minute (e.g. for 10.54am, press 1 0 5 4 and press
8PY`
.
Saved is displayed.
7. Press and hold
8`_P
to return to standby.
To change the time or date format
1. Press
8PY`
to open the main menu.
2. Press
.LWW^
or until the display shows Date/Time and press
8PY`
.
3. Press
.LWW^
or until Time format or Date format is displayed, as required.
4. Press
8PY`
and choose between 24hr/12hr or dd.mm/mm.dd as appropriate.
5. Press
8PY`
to confirm and press and hold
8`_P
to return to standby.
Your Telstra 7300/7300a is now ready for use.
Getting started
Signal strength
The
SIGNAL symbol on your handset screen indicates when you are in range.
When you are out of range, the symbol fl ashes, and the screen displays Searching. You should move closer to the
base if this happens to ensure the full functionality of your phone.
IMPORTANT
Do not connect the telephone line until at least one of the handsets is fully charged.
The base station must be plugged into the mains power at all times.
Talk/Standby time
Under ideal conditions, fully charged handset batteries should give approximately 10 hours talk time or 100 hours standby
time on a single charge.
Battery low warning
If the symbol is fl ashing, you will need to recharge your handset before using it.
Battery performance
To keep your batteries in the best condition, leave the handset off the base for a few hours at a time (after the initial 16 hour
charge). New NiMH batteries do not reach full capacity until they have been in normal use for several days. Running the
batteries right down at least once a week will help them last as long as possible. The charge capacity of rechargeable batteries
will reduce with time as they wear out, so reducing the talk/standby time of the handset. Eventually they will need to be
replaced. New batteries can be purchased from your local electrical retailer or from TecHelp on 1300 369 193.
Batteries and handset may become warm during charging. This is normal.
IMPORTANT
Only use the power supply and telephone line cord supplied with your Telstra 7300/7300a otherwise the telephone may not
work.