Filter
Top Products
12
PDT 8100 Series
Starting the PDT 8100
Press the red power button to turn the PDT 8100 on and off. If the
terminal does not power on, perform a hard reset. See Performing
a Hard Reset on page 28.
As the terminal initializes its unique Flash File system, the Symbol
splash screen displays for about 10 seconds.
When the Welcome screen appears, tap anywhere on the screen
to continue to the Align screen. Note that these screens also
appear every time you perform a hard reset.
Aligning the Screen
To align your PDT 8100 so the cursor on the touch screen aligns
with the tip of your stylus:
1. If necessary, adjust the contrast (monochrome LCD only) on
the PDT 8100 so the screen is readable. See Adjusting the
Contrast (Monochrome LCD) on page 14.
2. Remove the stylus from its storage silo on the back of the
PDT 8100.
3. Tap the center of each target that appears on the screen with
the tip of the stylus.
Power Button
Tap the target firmly and accurately at
each location on the screen. The target
will continue to move until the screen
is aligned.