Filter
Top Products
10
PDT 8100 Series
2. Insert the PDT 8100 terminal in the cradle.
3. The Terminal Status LED turns red (may take up to one
minute) to indicate charging, then turns off when the battery
is fully charged. The terminal’s battery is fully charged after
approximately 2 1/2 hours.
Charging a Spare Battery
To recharge a spare battery, insert it in the spare battery charging
slot in the back of the cradle, so the contacts are facing down and
towards the back of the cradle. Press the battery down into the slot
until firmly seated.
The Spare Battery LED turns red to indicate charging, then green
when the battery is fully charged. The battery is fully charged after
approximately 2 1/2 hours. See the CRD 8100-1000S Quick
Reference Guide (p/n 72-50974-xx) for more information.
Terminal Status LED
Spare Battery LED