Filter
Top Products
20
Making a Call
1. If one handset is in use, the other hand-
set will display “LINE IN USE” for 3 sec-
onds when TALK button is pressed.
2. Lift the handset and press the TALK
button to be connected to the phone line.
The LCD display will show “TALK” and
the TALK timer will start. The IN USE/
CHARGE LED on the base will light.
3. After hearing a dial tone, dial the de-
sired number. Or you may predial the num-
ber (without pressing the TALK button),
then press the TALK button.
4. If you misdial, simply press the TALK
button, wait for a couple of seconds, and
press the TALK button again for a new
dial tone.
5. After your conversation is completed,
press the TALK button once to discon-
nect the line, or return the handset to the
base.
Receiving a Call
When the phone rings:
1. IF THE HANDSET IS OUT OF THE
CRADLE, press the TALK button.
2. IF THE HANDSET IS IN THE CRADLE, lift
the handset. DO NOT press the TALK
button, as you will be connected automat-
ically.
TELEPHONE OPERATION (CONT.)
Temporary Tone Mode
In Pulse dialing mode, you can access bank
facilities, telephone answering machines,
etc., by simply pressing the TONE(‘ ’key)
to get into the tone mode and input the
required tone codes. It will reset automati-
cally after you end your call. By pressing
the FLASH button, you can return to the
pulse mode during the call.
NOTE:
If you experience difficulty with placing or
receiving calls, a lost security code may
be the cause of the problem. When this
occurs, the handset can no longer com-
municate with its base. The loss of the
code can occur any of the following ways:
if the battery is drained and needs recha-
rging; the handset is out of range of the
base unit; the AC adaptor is disconnected
or a power loss has occurred; or anthing
that causes electrical interference,for ex-
ample multiple cordless telephones, baby
monitors, televisions, VCR’s etc. Reset the
security code by placing the handset on
the base for 10 seconds. If that does not
work, make sure the AC adaptor is
connected. If necessary, unplug the AC
adaptor from the power source. Discon-
nect the battery for 5 seconds and then
reconnect. Place the handset on the base
and then replug the AC adaptor (see
Troubleshooting).
PAUSE