Filter
Top Products
16
Handsets ID Registration
1. After base unit installation has been finished, place the handsets on the base and
charger and make sure each handset is charged for 10~14 hours.
NOTE:
The handset which has been charged at the external charger must be
placed on the main base unit for about 5 seconds to make proper ID
registeration.
INSTALLATION (CONT.)
IMPORTANT: If there is no“ dial tone or LCD displays ‘ No Link ’ then,
1. Press and hold Page 1 button on the base and CH button on one of the handsets
simultaneously for 10 seconds, then the handset LCD will display H1.
2. Press and hold Page 2 button on the base and CH button on the other handset
simultaneously for 10 seconds, then the handset LCD will display H2.
This may need repeating in case of a power failure to re-register the unit.
Both of Handset 1 and Handset 2 must be placed into base for about 5 seconds.
Handset 1
Handset 2
TRAN
Handset 2 ( “H2”) ID registered
TRAN
Handset 1 (“H1”) ID registered