Filter
Top Products
DR-BT160iK_CED [US, ES] 4-108-812-42(1)
3736
US US
DR-BT160iK_CED [US, ES] 4-108-812-42(1)
3736
US US
Troubleshooting
If you run into any problems using this product, use the following
checklist and read the product support information on our website.
Should any problem persist, consult your nearest Sony dealer.
Symptom Cause / Remedy
e transmitter is
not turned on.
(Or turns o shortly
aer turning on.)
Press and hold the transmitter’s power button for
about 1 second.
Check the remaining battery of the iPod. If the
remaining battery is not enough, charge the iPod.
Reset your iPod.
If your iPod have no content, add some content to
your iPod.
e headset is not
turned on.
Charge the battery of the headset.
e headset is not turned on while charging. Unplug
the headset from AC power adaptor and then turn on
the headset.
No sound
Check the connection between the transmitter and
the iPod.
Check that both the transmitter and the headset are
turned on.
Ensure that the transmitter is not too far from the
headset, or this product is not receiving interference
from a wireless LAN, other 2.4 GHz wireless device,
or microwave oven.
Pair the transmitter and the headset again (page 27).
Check that music is being played back by the iPod.
Check that the volume of the headset is not set too
low.
Low sound level
Turn up the volume of the headset as high as possible
to the extent that sound is not distorted.
Cannot change the
volume.
Change the volume on the headset.
Distorted sound
Turn down the volume of the headset to the point
where the sound is no longer distorted.
Ensure that this product is not receiving interference
from a wireless LAN, other 2.4 GHz wireless device,
or microwave oven.
Turn o the EQ of iPod.