Filter
Top Products
DR-BT160iK_CED [US, ES] 4-108-812-42(1)
2726
US US
DR-BT160iK_CED [US, ES] 4-108-812-42(1)
2726
US US
Re-pairing the transmitter and the headset
1
Turn on the power of iPod.
(Make sure the iPod is in pause mode.)
2
Connect the transmitter to the iPod (page 16).
3
Place the transmitter and the headset to be paired together
within 1 m (3 ft).
4
Press and hold the PAIRING button of the headset for about 2
seconds or more to enter “Pairing in process” while the headset
is turned off.
e headset indicator (red) and the headset indicator (blue) will
ash together and the headset enters into pairing mode.
5
Press and hold the power button of the transmitter for about 7
seconds or more to enter “Pairing in process.”
Aer about 1 second, the transmitter indicator will ash twice,
but keep pressing the power button.
Notes
When rst power on the transmitter aer initialized, the transmitter will
enter “Pairing in process” automatically.
e pairing information is initialized if you press and hold the power button
for 15 seconds. e transmitter indicator lights up for 5 seconds before the
initialization starts. Release the button immediately when the transmitter
indicator lights up.
Pairing in process” is released aer about 5 minutes. If pairing is not
established within about 5 minutes, repeat the above procedure from step
4
.
iPod backlight may turn on in this 5 minutes.
To enter “Pairing in process,” you need to turn o the power of the
transmitter rst.
•
•
•
•