Filter
Top Products
B. Install the rechargeable battery pack into the handset
The handset is powered by a rechargeable battery pack.
The battery recharges automatically when the handset is placed in
the base unit.
Charge the handset battery pack for at least 15-20 hours before
using your new cordless telephone for the first time! To maximize
the charge capacity of your battery pack, DO NOT plug the telephone
cord into the base unit and wall jack until the battery is fully charged.
1 Press down on the handset battery case
cover (use the finger indention for a
better grip) and slide the cover
downward to remove.
2 Plug the battery pack connector (red &
black wires) into the small, black jack
inside the battery compartment. (The
connector notches fit into the grooves
of the jack only one-way.) Match the
wire colors to the polarity label in the
battery compartment, connect the
battery and listen for a click to
ensure connection.
3 Make sure you have a good connection
by pulling slightly on the battery wires.
If the connection is secure, the battery
jack will remain in place.
4 Place the battery case cover back on the
handset by sliding it upwards until it
clicks into place.
Use only the Sanyo rechargeable battery pack supplied with your
cordless telephone.
IMPORTANT
E5
GETTING
STARTED
Red
Wire
Black
Wire
Red
Black
UP015DH(CLT5810) ENG OM 3/9/05 10:36 AM Page 5