Filter
Top Products
5
WALL MOUNT INSTALLATION
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
LOWER
THIS END UP FOR WALL USE
THIS END UP FOR DESK USE
1. Rotate the handset hook.
2. Remove the base plate from the back by
pressing down on the snap tabs located at
the top, and then lifting the base plate off.
3. Plug the phone line cord into the phone
jack on the back of the unit, wrap the extra
line cord around the cord wrap on the
bottom of the base, and then thread it
through the bottom of the base plate.
4. Plug the power supply adapter into the
POWER 9V AC jack on the back of the unit,
and then thread it through the bottom of
the base.
5. Reverse the direction of the base plate and
replace it by putting the tabs into bottom
slots in the middle of the unit first, and
then snapping the bottom tabs into place.
6. Set the PULSE/TONE switch (located on the
side of the unit) to TONE if you have touch-
tone service; set it to PULSE if you have
rotary service.
7. Connect the phone cord to the modular
jack on the wall.
8. Slip the mounting holes over the wall plate
posts and slide the unit down firmly into
place. (Wall plate not included.)
9. Plug the handset cord into the handset and
into the unit, and then hang up the
handset.
10. Connect the AC Power supply adapter to an
AC outlet.