RCA 2-9398 Telephone User Manual


 
12
HOLD
Use the HOLD button to interrupt a phone
conversation without hanging up; then
resume the conversation on the same
phone or an extension.
1. Press HOLD to place a call on hold. If
you're using the handset, you can put it
back in the cradle.
NOTE: While a call is on
hold, the HOLD
indicator will flash, and
the phone will beep
about every 15 seconds
to remind you that the
line is on hold.
2. Press the SPEAKER button, pick up the handset, or press HOLD (if the
handset is not in the cradle) to resume the conversation.
MUTE
The MUTE button deactivates the microphone for both the speakerphone
and the handset, so that anything you say cannot be heard by the caller
on the other end of the line.
Press MUTE once to turn on the feature.
Press MUTE again to continue the phone conversation.
Picking up the handset while the speakerphone is muted automatically
turns off the mute function.
DO NOT DISTURB
The Do Not Disturb feature lets you mute the ringer volume for a
predetermined amount of time so that you are not interrupted by incoming
phone calls.
Press the NO DISTURB button (the indicator starts blinking). The Do
Not Disturb feature is automatically activated for one hour.
To turn off the feature, you can press the NO DISTURB button again,
pick up the handset, or press SPEAKER (the indicator turns off).
USING DO NOT DISTURB
PROGRAMMING THE DO NOT DISTURB TIME
You can adjust the amount of time it is
active by following these steps:
1. Press the STORE button.
2. Press a number key (0-9) to choose the number of hours you want the
feature to remain active from unlimited duration to nine hours
(0 = unlimited duration).
3. Press the STORE button again.
4. Press the NO DISTURB button.
10/22 07:15
AM
DND
- 2
HOURS