Filter
Top Products
22
If you make a mistake, move the
cursor over the error, then enter the
correct character, or press
DEL/CH
to delete a character. To delete all
the characters, hold down
DEL/CH
for at least 1 second.
6. Press
SELECT
. Store Number
appears.
7. Enter the phone number and any
tone or pause entries (see “Using
Tone Services on a Pulse Line” on
Page 18 and “Entering a Pause” on
Page 23).
8. Press
SELECT
. The phone beeps
and
Memory n Stored appears.
After 2 seconds,
Memory Store
appears. Repeat Steps 3–8 to store
more numbers.
9. When you finish, press
MEM
to exit
Memory Store.
Use the supplied memory directory
sticker to record your stored numbers.
Peel the backing from the sticker and at-
tach it to the base.
To replace a stored number, store a new
one in its place.
In the Base
1. Press
MEMORY
. The CHARGE/IN
USE indicator blinks.
2. Enter the phone number and any
tone or pause entries (see “Using
Tone Services on a Pulse Line” on
Page 18 and “Entering a Pause” on
Page 23).
3. Press
MEMORY
again, then enter
the memory location number (
0
–
9
)
where you want to store the number.
A tone sounds to indicate that the
number is stored.
To clear a stored number, simply store a
new number in its place. Or, press
MEM-
ORY
twice. Then press the memory lo-
cation number (
0
–
9
) you want to clear. A
tone sounds.
Use the supplied memory directory
sticker to record your stored numbers.
Peel the backing from the sticker and at-
tach it to the base.
MEMORY