Filter
Top Products
12
1. Drill two holes 3
15
/
16
inches (100 mm)
apart. Then thread
a screw into each
hole, letting the
heads extend about
5
/
16
inch (8 mm)
from the wall.
2. Plug one end of the supplied long
modular cord into the
TEL LINE
jack
on the back of the base.
3. Align the bracket’s keyhole slots
with the mounting screws and slide
the base downward to secure it.
CONNECTING AND
CHARGING THE
BATTERY PACK
The TAD-727 comes with a recharge-
able nickel-cadmium battery pack in the
handset but not connected. Before using
your phone, you must connect the bat-
tery pack, then charge it for about 12
hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the com-
partment.
3. Plug the battery pack's connector
into the socket in the compartment
(the connector fits only one way),
route the battery pack's leads
through the strain relief slot and
place the battery pack into the com-
partment.
Note:
When you connect the bat-
tery, the TALK/LOW/BATT indicator
flashes (when in the phone is not in
use) indicating that the security
access protection code on the hand-
set was lost.
To reset the code, return the hand-
set to the base for about 2 seconds.
4. Replace the cover.
5
/
16
3
15
/
16
43-727.fm Page 12 Monday, December 20, 1999 4:28 PM