Filter
Top Products
9
Preparation
6. Plug the adapter into a standard AC out-
let.
SETTING THE DIALING
MODE
Set
T/P
(Tone/Pulse) for the type of service
you have. If you are not sure which type you
have, do this simple test.
1. Be sure
T/P
is set to
T
.
2. Lift the handset and listen for a dial tone.
3. Press any number except 0.
Note:
If your phone system requires that
you dial an access code (9, for example)
before you dial an outside number, do
not press the access code either.
If the dial tone stops, you have touch-
tone service. If the dial tone continues,
you have pulse service.
4. If you have pulse service, set
T/P
to
P
.
Otherwise, leave it set to
T
.
SETTING THE RINGER
RINGER
OFF.LO.HI
controls the TAD’s ringer
volume. To adjust the ringer volume, set
RINGER
OFF.LO.HI
to
HI
or
LO
.
If you do not want the ringer to sound, set
RINGER
OFF.LO.HI
to
OFF
. You can still make
calls with the ringer off, and you can answer
calls if you hear another phone on the same
phone line ring or if
RING
appears on the
display.
SETTING THE DISPLAY
CONTRAST
1. Hold down
STOP
until the TAD beeps
once.
3
and
LCD
CONTRAST
appear.
3
flashes.
2. Repeatedly press
:
::
:
/
8
88
8
to select the
desired display contrast settings.
Note:
The TAD has ten (0–9) display
contrast settings.
3. Press
DIAL
to confirm the setting, then
press
STOP
to return to the time display.
SETTING THE LONG
DISTANCE CODE
The Long Distance Code has a default set-
ting of 1. You can change the code to “9” if
you use a PBX telephone system or “0” if
your telephone system requires operator as-
sistance to make a long distance call.
Note:
If you do not complete each step with-
in 8 seconds, the TAD exits setup. Start
again at Step 1.
1. Hold down
STOP
until the TAD beeps
once.
2. Press
DIAL
once.
1
and
SET
LDS
CODE
appear.
1
flashes.
3. Repeatedly press
:
::
:
/
8
88
8
to set the long
distance code to
1
,
9
, or
0
.
4. Press
DIAL
then press
STOP
to return to
the time display.
SETTING THE AREA CODE
Note:
If you do not complete each step with-
in 8 seconds, the TAD exits setup. Start
again at Step 1.
1. Hold down
STOP
until the TAD beeps
once.
43-705.fm Page 9 Tuesday, May 23, 2000 8:54 AM