Filter
Top Products
10
Preparation
2. Press
DIAL
twice.
000
and
SET
AREA
CODE
appear. The first
0
flashes.
3. Repeatedly press
:
::
:
/
8
88
8
until the first
digit of your area code appears, then
press
9
99
9
/
;
;;
;
to the second digit. The
second
0
flashes.
Note:
If you make a mistake, repeatedly
press
9
99
9
/
;
;;
;
to move the cursor to the
position of the incorrect digit then re-
enter the code.
4. Repeat Step 3 to set the second and
third digits of your area code.
5. Press
DIAL
then press
STOP
to return to
the time display.
SETTING THE DAY, TIME
AND DATE
To avoid losing the day and time settings if
AC power fails, we recommend you install a
backup battery before you set the day and
time (see “Installing a Backup Battery” on
Page 7).
Follow these steps so the TAD can record
the correct day and time each message and
memo is recorded.
Note:
If you do not complete each step with-
in 8 seconds, the TAD exits setup. Start
again at Step 1.
1. Hold down
STOP
until the TAD beeps
once.
2. Repeatedly press
DIAL
until
SUNDAY
appears.
3. Repeatedly press
:
::
:
/
8
88
8
to select
AM
or
PM
.
4. Press
9
99
9
/
;
;;
;
. The hour digit flashes.
5. Repeatedly press
:
::
:
/
8
88
8
to set the cor-
rect hour.
6. Repeat Steps 4 and 5 to set the minute,
month, date, and the day of the week.
7. Press
DIAL
then press
STOP
to return to
the time display.
SETTING THE NUMBER OF
RINGS
Set the ring select switch to
2
,
4
,
7
, or
TS
(Toll
Saver) to set how long the TAD waits before
it answers a call (2 rings, 4 rings, 7 rings or
toll-saver).
If you plan to check your messages by long
distance, set the ring select switch to
TS
.
43-705.fm Page 10 Tuesday, May 23, 2000 8:54 AM