Filter
Top Products
14
CHARGING THE
HANDSET BATTERY
PACK
You must charge the battery pack at
least 24 hours before you use the TAD-
1010 the first time or when you replace
the battery pack. To charge or recharge
the battery pack, simply place the hand-
set on the cradle. The CHARGE indica-
tor lights.
Notes:
• If the CHARGE indicator does not
light or blinks continuously when
you place the handset on the cra-
dle, be sure the battery pack and
AC adapter are correctly and
securely connected. Also, check the
charging contacts on both the hand-
set and base. If the contacts are
dirty or tarnished, clean them with a
pencil eraser.
• If the handset is charged, and the
AC adapter is unplugged from the
AC outlet or the AC outlet loses
power, the handset beeps intermit-
tently until power is restored to the
base and the security access-
protection code is reset. To turn off
the handset sooner so it stops
beeping, press
TONE
,
#
, or any
number key (
0
-
9
).
IN USE
REPEAT STOP PLAY SKIP
CHARGE
PAGE
DIGITAL
• If the base loses AC power and the
handset is away from the base,
place the handset on the base for a
few seconds after AC power is
restored. This resets the security
access-protection code.
You can recharge the battery pack at
any time, but you must be sure to re-
charge the battery pack when the hand-
set’s PRIVACY/LOW BATT indicator
lights.
If the battery pack will not hold a
charge, replace it. We recommend you
replace the battery pack about once a
year.
Notes:
• The first time you use your phone
after charging a new or completely
discharged battery pack, the hand-
set might not work or it might
sound an error tone when you
press
TALK
. If this happens, return
the handset to the base for about 5
seconds, then try again.
TALK CH OFF
PRIVACY / LOW BATT
1
4
7
2
5
8
0
3
6
9
#
GHI
PRS
TONE
ABC
JKL
TUV
OPER
DEF
MNO
WXY
HOLD FLASH PRIVACY
MEM REDIAL
PROG
43-771.fm Page 14 Friday, August 13, 1999 2:59 PM