Filter
Top Products
8
On a Wall
To mount the phone directly on a wall,
you need two screws (not supplied) with
heads that fit into the keyhole slots on
the bottom of the base. Follow the steps
under “On a Wall Plate” on Page 7, then
apply these additional instructions for
placement on a wall.
1. Drill two holes 3
15
/
16
inches (100 mm) apart.
Then thread a screw
into each hole, letting
the heads extend about
5
/
16
inch (8 mm) from the
wall.
2. Plug one end of the supplied long
modular cord into the
TEL LINE
jack
at the back of the base.
3. Align the bracket's keyhole slots
with the mounting screws and slide
the base downward to secure it.
CONNECTING AND
CHARGING THE BATTERY
PACK
The phone comes with a rechargeable
nickel-cadmium battery pack installed in
the handset, but not connected. Before
using your phone, you must connect the
battery pack, then charge it for about 24
hours.
1. Press down and slide off the battery
pack compartment cover.
2. Lift the battery pack out of the com-
partment. Plug the battery pack's
connector into the socket in the
compartment. The connector fits
only one way.
3. Put the battery pack in the compart-
ment.
4. Replace the cover.
To charge the battery pack, simply place
the handset on the base, facing either
up or down. The CHARGE/IN USE indi-
cator on the base lights.
Recharge the battery pack when
Low
Battery
flashes on the handset's dis-
play.
43-1123.fm Page 8 Tuesday, September 5, 2000 11:13 AM