Filter
Top Products
14
USING BOTH THE
HANDSET AND THE
SPEAKERPHONE
If someone else is using the speaker-
phone, press
TALK
on the handset to
join the conversation. If someone else is
using the handset, press
SPEAKER
on
the base to join the conversation.
Con-
ference
appears on the base's dis-
play and CHARGE/IN USE lights.
During the call, one person can hang up
and let the call continue at the other key-
pad. Or, both people can hang up to end
the call.
Note:
If you hear a high-pitched noise
from the base's speaker, the handset
and the base are too close together.
USING FLASH
Flash performs the electronic equiva-
lent of a switchhook operation for spe-
cial services, such as Call Waiting. For
example, if you have Call Waiting, press
FLASH
to answer an incoming call with-
out disconnecting the current call. Press
FLASH
again to return to the first call.
Note:
If you do not have any special
phone services, pressing
FLASH
might
disconnect the current call.
USING REDIAL
To quickly dial any of the last three num-
bers dialed on the handset, lift the hand-
set and press
REDIAL/PAUSE
. The last
number dialed on the handset appears
below
<Redial
1>
. Press
REDIAL/
PAUSE
repeatedly until the desired num-
ber appears on the display, then press
TALK
.
To dial the last number dialed on the
base, press
REDIAL
on the base. The
last number dialed on the base appears
on the base's display. Then press
SPEAKER
. You can redial only the last
number on the base.
Notes:
• The redial memory is separate for
each keypad. You cannot redial a
number you dialed on the handset
keypad using
REDIAL
on the base,
and vice versa.
• The redial memory holds up to 32
digits, so you can redial any long-
distance number as well as local
numbers.
• The redial memory also holds pause
entries (see “Entering a Pause” on
Page 19).
USING TONE SERVICES
ON A PULSE LINE
Some special services, such as bank-
by-phone, require tone signals. If you
have pulse service, you can still use
these special tone services by following
these steps.
1. Be sure
DIAL MODE P- -T
is set to
P-
.
43-1123.fm Page 14 Tuesday, September 5, 2000 11:13 AM