Filter
Top Products
24
If you still have problems, disconnect the phone. If other phones on the same line work proper-
ly, the fault is in this phone or its installation. If you cannot find the problem, take your phone to
your local RadioShack store for assistance.
The handset stops working or
works poorly during a call.
Move the handset closer to the base.
Lift the base's antenna to a vertical position.
Be sure the battery pack is charged. (If the battery power is
too low, it does not have enough power to light the display.)
If the base loses power while the handset is away, the secu-
rity access-protection code might change. Restore power to
the base, then place the handset back on the base. The
CHARGE/IN USE indicator lights, indicating that the code is
set again.
Check the charging contacts on the handset and base. If
they are dirty, clean them with a pencil eraser.
Low Battery
flashes
on the display every few sec-
onds.
Be sure the battery pack is correctly connected.
You have an incoming call,
but do not receive any Caller
ID information.
Let the phone ring twice before you answer so the system
has time to record the Caller ID information.
Check that the system is correctly and securely connected.
Call your phone company to verify that your Caller ID service
is active.
Problem Suggestion
43-1123.fm Page 24 Tuesday, September 5, 2000 11:13 AM