Filter
Top Products
8
Installing Your Telephone
3. Insert the supplied AC adapter’s barrel plug
into the
DC IN 9V jack on the back of the base.
4. Route the adapter’s cord through the strain
relief slot on the back of the base.
5. Plug the adapter into a standard AC outlet.
6. Lift the base's antenna to a vertical position.
On a Wall Plate
1. Plug one end of the supplied short modular
cord into the
TEL LINE jack on the back of the
base.
2. Insert the supplied AC adapter’s barrel plug
into the
DC IN 9V jack.
3. Route the adapter’s cord through the grooves
on the bottom of the base.
4. Plug the modular
cord into the wall
plate jack. Then
align the base's
keyhole slots with
the wall plate
studs and slide
the base down to
secure it. Plug the
adapter into a
standard AC
outlet.
5. Lift the base’s antenna to a vertical position.
On a Wall
To mount the phone directly on a wall, you need
two screws (not supplied) with heads that fit into the
keyhole slots on the bottom of the base.
1. Drill two holes 3
15
/16 inches (100 mm) apart.
Then thread a screw into each hole, letting the
heads extend about
1
/8 inch (3 mm) from the
wall.
43-3815/3898.fm Page 8 Wednesday, May 7, 2003 10:31 AM