Filter
Top Products
Remote Operation
43
answer calls, it will answer after about ten rings
and sound a series of beeps.
2. When the outgoing message begins (or the
system sounds a series of beeps), press #.
Then enter your security code within 2
seconds.
3. If the code is correct, the system announces
the number of new and old messages, and
then “To play incoming message, press #
2. For
help, press #
0." If the system does not
respond, try entering your code again. If you
enter an incorrect code three times, the system
beeps and disconnects.
4. While the system is beeping, press
# and
(within 2 seconds) the number for the desired
command.
Press # then To
1
Repeat current message during
playback. If you press # 1 within about
4 seconds after a message begins, the
previous message replays (unless it is
the first new message).
2
Play messages. The remote playback
for incoming messages is limited to 4
minutes. If you have more messages,
you must press # 2 again to listen to
the rest of the messages.
3 Skip current message during playback.
4
Delete current message during
playback. You can only delete the
current message, you cannot delete all
the stored messages.
5 Stop playback or recording.
6
Set the system to answer calls.
Announces the current outgoing
message.
43-3815/3898.fm Page 43 Wednesday, May 7, 2003 10:31 AM