Filter
Top Products
SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
PN: 72-1084-02-G.doc Page 7
2.2 Quick Start Guide
1. A wireless LAN must be properly configured and operational through the use of
802.11b APs listed on the
NetLink Wireless Telephone Access Point Compatibility
matrix.
2. A TFTP server must be available on the network in order to load the appropriate
software into the NetLink Wireless Telephones. See the
License Management
section for detailed instructions for loading software on NetLink Wireless
Telephones.
3. The supported Mitel Networks VoIP solution must be connected to your
network and completely operational.
4. The NetLink SVP Server, which facilitates the QoS on the wireless LAN for the
NetLink Wireless Telephones, must be on the same subnet as the NetLink
Wireless Telephones and have the proper versions of software.
Ensure you have the following versions for the SVP Server:
173 svp100.toc
174 zvmlinux
175 flashfs
5. Visit http://www.polycom.com/usa/en/support/voice/wi-fi/wi-fi.html to
download the latest NetLink Wireless Telephone and any updates to the NetLink
SVP Server software.
6. Install the correct NetLink Wireless Telephone software and any updates to the
NetLink SVP Server software per Section 5.2
Configuration Process
for the
NetLink Wireless Telephones and per
NetLink SVP Server Installation, Setup
and Maintenance
section 6.1
Software Updates
for the NetLink SVP Server.
Ensure the software is properly loaded on the TFTP server.
7. Configure your NetLink Wireless Telephone to ensure that it is associated with
the wireless LAN, has the appropriate software, and has the correct IP address
for the supported Mitel Networks IP telephony system. See the
License
Management
section and the
NetLink Wireless Telephone Configuration
section for
detailed instructions for loading software onto and configuring NetLink Wireless
Telephones.
IP multicast addresses are used by the NetLink i640 Wireless Telephone.
This requires that multicasting be enabled on the subnet used for the
NetLink Wireless Telephones and SVP Server.
Routers are typically configured with filters to prevent multicast traffic
from flowing outside of specific domains. The wireless LAN can be placed
on a separate VLAN or subnet to reduce the effects of broadcast and
multicast traffic from devices in other network segments.