Filter
Top Products
SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
PN: 72-1084-02-G.doc Page 24
1100, and 1200 APs may require a firmware upgrade to support FSR. Cisco FSR
requires advanced configuration of the Cisco access points in your site. See your
Cisco representative for detailed documentation on configuring your access points
and other required security services on your wired network. To configure Cisco FSR
in your NetLink Wireless Telephone, you must enter a Radius Server username and
password into each handset.
Username Enter a username that matches an entry on your Radius server.
Usernames are alphanumeric strings, and can be entered using the alphanumeric
string entry technique.
Password Enter the password that corresponds to this Username.
WPA-PSK The security features of WPA (Wi-Fi Protected Access) using PSK (Pre-
Shared Key) are available and may be used if supported by the access points in the
facility. Select either Passphrase and enter a passphrase between eight and 63
characters in length or Direct Entry and enter the 256-bit key code.
WPA2-PSK The security features of WPA2 (Wi-Fi Protected Access) using PSK
(Pre-Shared Key) are available and may be used if supported by the access points in
the facility. Select either Passphrase and enter a passphrase between eight and 63
characters in length or Direct Entry and enter the 256-bit key code.
Consult the
Configuration Note
for the access points (APs) installed in
your facility for information on which of the WPA versions are
recommended by SpectraLink engineering. Configure the recommended
version on the AP and select the corresponding option on the Admin
menu.
Regulatory Domain
The Regulatory Domain will default to North America on the handset display. FCC
requirements dictate that the menu for changing the domain be available by
password, which in our case is the LINE key. To change the domain, press LINE and
then enter the digits that represent the site’s domain. Note that both digits must be
entered.
01 - North America
02 - Europe (except Spain and France); Japan (channels 1-13)
04 - Spain
05 – France
As of this writing, Spain and France are adopting the general European
Regulatory rules. Check with your wireless LAN administrator or
supplier for which domain to enter in these countries.
Transmit Power
Available transmit power is regulated by domain. The Regulatory Domain setting
above affects the options available for this setting. The default setting is
Maximum
which in North America is 100 mW. The Maximum in other domains is 30 mW.
Transmit Power may be set to a lower number if necessary by selecting one of the
other levels. If changed from the default, ensure the Transmit Power setting is the
same on all handsets and all APs.