Filter
Top Products
SpectraLink Corporation Configuration and Administration—NetLink e340/i640 Wireless Telephone
Mitel Networks 3300 and SX-200 ICP and 5220 IP Phone emulation
PN: 72-1084-02-G.doc Page 52
12.3 NetLink Wireless Telephone Status Messages
NetLink Wireless Telephone status messages provide information about the NetLink
e340/h340/i640 Wireless Telephone's communication with the AP and host
telephone system. The following table summarizes the status messages, in
alphabetical order.
Message Description Action
3 chirps Handset is not able to communicate with the
best AP, probably because that AP has no
bandwidth available.
None. This is only a warning, the call will
handoff to the best AP once it becomes
available.
Address Mismatch Handset software download files are
incorrect or corrupted
Download new software from the
SpectraLink site per
Software
Maintenance
.
ASSERT xxx c
Line yyy
The handset has detected a fault from which
it cannot recover.
Record the error code so it can be
reported.
Turn the handset off then on again.
If error persists, try registering a different
handset to this telephone port.
If error still persists, contact SpectraLink
Technical Support and report the error.
Assoc Failed
xxxxxxxxxxxx
x…x = AP MAC address.
Handset association was refused by AP;
displays MAC of failing AP.
Check handset and AP security settings.
Ensure AP is configured per
Configuration
Note
.
Try another AP.
Assoc Timeout
xxxxxxxxxxxx
x…x = AP MAC address.
Handset did not receive association
response from AP; displays MAC of failing AP
Check handset and AP security settings.
Ensure AP is configured per
Configuration
Note
.
Try another AP.
Auth Failed
xxxxxxxxxxxx
x…x = AP MAC address.
Handset authentication was refused by AP;
displays MAC of failing AP
Check handset and AP security settings.
Ensure AP is configured per
Configuration
Note
.
Try another AP.
Auth Timeout
xxxxxxxxxxxx
x…x = AP MAC address
Handset did not receive authentication
response from AP; displays MAC of failing AP
Check handset and AP security settings.
Ensure AP is configured per
Configuration
Note
.
Try another AP.
Bad Code Type xx
Expected Code Type yy
xx, yy = software license types
Handset software does not match current
handset license selection
Download new software from the
SpectraLink site per
Software
Maintenance
.
Bad Config Some needed configuration parameter has
not been set
Check all required handset configuration
parameters for valid settings
Bad ESSID The handset is configured for “static ESSID”
(as opposed to “Learn once” or “Learn
always” and no ESS ID has been entered.
Enter an ESSID in the configuration
settings or change to one of the “Learn”
modes.
Bad Phintl File Handset software download files are
incorrect or corrupted
Download new software from the
SpectraLink site per
Software
Maintenance
.